I was in a hurry, started the print, and after 7 minutes an error appeared in the application:
Z axis homing failed; the task has been stopped.[0300-4000 000404].
What does this error mean?
This message means that during calibration (homing) on the Z axis, the 3D printer was unable to find the zero position. As a result, the task was stopped to avoid damage.
The build plate may not be properly placed. If this message appears repeatedly, please check the Wiki for more
Possible causes:
❌ The Z-axis endstop did not trigger or is faulty
🧷 Physical obstruction of the Z-axis movement
🔌 Issues with motor or sensor connections
⚙️ Incorrect configuration in the firmware or G-code
What to do?
Check if anything is blocking the movement on the Z-axis
Ensure that the endstop is working (press manually and check the response)
Check cables and connections
Restart the device and try again
But my printer is less than a month old. What went wrong?It's quite simple. I was in a hurry and inserted the plate a bit crooked. I aligned it, restarted the print, and everything was fine. But I noticed that the printer dropped one poop right under the plate. So don't forget to check the printer before starting the print.
To resolve other possible issues, BambuLab recommends visiting the official Wiki page for a breakdown of this error.
